Retaining Structures in Slope Stabilization: A Comparative Analysis on Safety and Cost Effectiveness
DOI:
https://doi.org/10.61186/7.3.15Keywords:
Slope Stabilization, Retaining Structures, Cost-Effectiveness Analysis, PLAXIS 2D, Natural DisasterAbstract
This study evaluates slope stabilization methods using gravity stone walls, reinforced concrete cantilever walls, and pile shoring systems. Stability and economic performance of these systems were compared through analyses conducted with Plaxis 2D and İstCAD software on a model slope subjected to increasing excavation depths. Results show that gravity stone walls are more economical up to 5 m, while cantilever walls are preferable between 5–9 m. Beyond 9 m, both methods become inadequate, and pile shoring systems provide the most effective solution. Each method's advantages and limitations were assessed based on field applicability, cost, and stability.
References
[1] Anaç, İ. and A. Şirin. “Landslide Identification and Data Generation Guide.” Ankara (2015).
[2] Seçkin, F. and G. Tolga. “Distribution characteristics of fatal landslides in Türkiye and determination of priority areas at national scale.” Turkish Geography Journal 74 (2020): 123–134. https://doi.org/10.17211/tcd.731596
[3] Şahan, C. “A research on natural disasters in Turkey.” Ordu University Social Sciences Institute Social Sciences Research Journal 14.2 (2024): 414–428. https://doi.org/10.48146/ODUSOBIAD.1176360
[4] Matpay, B. and S. Mutlu. “Determining the Natural Disaster Diversity of Van Province by Fine Kinney Risk Assessment Method (FK-RAM).” Coruh University Natural Disasters Application and Research Center Natural Disasters and Environment Journal 9.2 (2023): 324–340. https://doi.org/10.21324/dacd.1295546
[5] Öz, T. and H. Günek. “Landslide Susceptibility and Settlement Risk Analysis of Solakli Basin (Trabzon).” International Journal of Geography and Geography Education 44 (2021): 396–412. https://doi.org/10.32003/igge.931516
[6] Şahin, Ş. “The Disaster Management in Turkey and Goals of 2023.” Turkish Earthquake Research Journal 1.2 (2019): 180–196.
[7] Ausilio, E., E. Conte, and G. Dente. “Stability analysis of slopes reinforced with piles.” Computers and Geotechnics (2001): 591–611.
[8] Li, X., S. He, and C. Wang. “Stability analysis of slopes reinforced with piles using limit analysis method.” Proceedings of Geo-Shanghai International Conference (2006): 105–112. https://doi.org/10.1061/40863(195)8
[9] Ashour, M. and A. Hamed. “Analysis of pile stabilized slopes based on soil–pile interaction.” Computers and Geotechnics 39 (2012): 85–97.
[10] Cai, F. and K. Ugai. “Numerical analysis of the stability of a slope reinforced with piles.” Soils and Foundations 40 (2000): 73–84.
[11] Lei, H., X. Liu, Y. Song, and Y. Xu. “Stability analysis of slope reinforced by double-row stabilizing piles with different locations.” Natural Hazards 106.1 (2021): 19–42. https://doi.org/10.1007/s11069-020-04446-2
[12] Griffiths, D. V. and R. M. Marquez. “Three-dimensional slope stability analysis by elasto-plastic finite elements.” Geotechnique 57.6 (2007): 537–546. https://doi.org/10.1680/geot.2007.57.6.537
[13] Mujah, D., A. F. I. H. Hazarika, A. S. A. Rashid, N. H. M. Nor, and S. N. L. Taib. “The Design Method of Slope Stabilizing Piles: A Review.” International Journal of Civil Engineering and Technology 3.2 (2013).
[14] Du, C., J. Chen, S. Chen, M. Peng, and Z. Shi. “Numerical analysis of a slope stabilized with piles and anchor cable frame beams.” Environmental Earth Sciences 82.4 (2023): 100. https://doi.org/10.1007/s12665-023-10784-8
[15] Vaughan, P. R. “Three-dimensional slope stability analysis by elasto-plastic finite elements.” Geotechnique 58.8 (2008): 683–685. https://doi.org/10.1680/geot.2008.D.010
[16] Cheng, X., Y. Zhang, Y. Zhang, Y. Zhao, and S. Wang. “Different aspects regarding slope stability improvement using piles.” IOP Conference Series: Materials Science and Engineering 1304.1 (2024). https://doi.org/10.1088/1757-899x/1304/1/012009
[17] Wei, W. B. and C. Yung Ming. “Strength reduction analysis for slope reinforced with one row of piles.” Computers and Geotechnics 36.7 (2009): 1176–1185.
[18] Jiang, J. H., X. L. Huang, X. R. Shu, X. Ning, Y. Qu, and W. L. Xiong. “Application of a damage constitutive model to pile–slope stability analysis.” Frontiers in Materials 9 (2022). https://doi.org/10.3389/fmats.2022.1082292
[19] Yumrutaş, H. İ., İ. Keskin, and U. Aydın. “Comparative Analysis of Geosynthetic Reinforced Earth Wall and Reinforced Concrete Retaining Wall: Kastamonu-Karabuk Highway Case Study.” Bilecik Şeyh Edebali Üniversitesi Fen Bilimleri Dergisi 9.1 (2022): 225–240.
[20] Yilmaz, I., T. Ekemen, M. Yildirim, I. Keskin, and G. Özdemir. “Failure and flow development of a collapse induced complex landslide: The 2005 Kuzulu (Koyulhisar, Turkey) landslide hazard.” Environmental Geology 49.3 (2006): 467–476. https://doi.org/10.1007/s00254-005-0113-0
[21] Keskin, İ., F. Karataş, and S. Kahraman. “Investigation of The Effects of Earthquake Characteristics on Slope Stability Using Model Slope.” Uludağ Üniversitesi Mühendislik Fakültesi Dergisi 27.2 (2022): 785–802. https://doi.org/10.17482/uumfd.1098502
[22] Öztürk, E. H. and Türkeli. “Optimum design of RC Retaining walls with key section using jaya algorithm.” Journal Of Polytechnic-Politeknik Dergisi (2019). https://doi.org/10.2339/politeknik.432031
[23] Varga, R., B. Žlender, and P. Jelušič. “Multiparametric analysis of a gravity retaining wall.” Applied Sciences (Switzerland) 11.13 (2021). https://doi.org/10.3390/app11136233
[24] Shah, D. J. “Stability Analysis of Gravity Retaining Wall by DEM Simulation.” ESP International Journal of Advancements in Science & Technology (ESP-IJAST) 2.4 (2024): 1–5. https://doi.org/10.56472/25839233/ijast-v2i4p101
[25] Varga, R., B. Žlender, and P. Jelušič. “Optimization of Embedded Retaining Walls Under the Effects of Groundwater Seepage Using a Reliability-Based and Partial Factor Design Approach.” Applied Sciences 14.23 (2024): 11135. https://doi.org/10.3390/app142311135
[26] Bari, F., J. A. Repadi, Andriani, F. A. Ismail, and A. Hakam. “Optimal Cost of Slope Stabilization With Retaining Wall.” Geomate Journal 22.93 (2022): 83–90. https://doi.org/10.21660/2022.93.3129
[27] Ma, X., Y. Liu, Z. Hao, X. Wang, and Y. Yang. “Study on stress and deformation characteristics of existing-new two-stage cantilever retaining wall.” PLoS One 19.2 (2024): e0296330. https://doi.org/10.1371/journal.pone.0296330
[28] Tierney, L. and M. Safiuddin. “Insights into Concrete Forming, Reinforcing, and Pouring in Building Construction.” Buildings 12.9 (2022): 1303. https://doi.org/10.3390/buildings12091303
[29] Mohammad, F. A. and H. G. Ahmed. “Optimum Design of Reinforced Concrete Cantilever Retaining Walls according Eurocode 2 (EC2).” Athens Journal of Technology and Engineering 5 (2018): 253–277. https://doi.org/10.30958/ajte.5-3-4
[30] Tornborg, J., M. Karlsson, and M. Karstunen. “Permanent Sheet Pile Wall in Soft Sensitive Clay.” Journal of Geotechnical and Geoenvironmental Engineering 149.6 (2023). https://doi.org/10.1061/jggefk.gteng-10955
[31] Yost, K. M., A. Yerro, R. A. Green, E. Martin, and J. Cooper. “MPM Modeling of Cone Penetrometer Testing for Multiple Thin-Layer Effects in Complex Soil Stratigraphy.” Journal of Geotechnical and Geoenvironmental Engineering 148.2 (2021): 04021189. https://doi.org/10.1061/(asce)gt.1943-5606.0002730
[32] Pham, T., A. Palma, T. Nguyen, and T. Vu. “Investigating Lateral Displacement of Pile Groups under Construction Loads and Excavation—A Case Study.” (2022): 1–14. https://doi.org/10.1061/9780784484029.001
[33] Zhang, C., L. Su, W. Chen, and G. Jiang. “Full-scale performance testing of bored piles with retaining walls in high cutting slope.” Transportation Geotechnics 29 (2021). https://doi.org/10.1016/j.trgeo.2021.100563
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Journal of Civil Engineering Researchers
This work is licensed under a Creative Commons Attribution 4.0 International License.
